Slide 2 Arm Pendant: Sloped Ceiling Installation Tips

By Ravenhill Studio | Published: 2026-10-27

Category: How-to Guides

Learn how to install the Slide 2 Arm Pendant on a sloped ceiling with practical steps, common mistakes, and essential safety checkpoints.

Quick Answer

To install a Slide 2 Arm Pendant on a sloped ceiling, use an adjustable canopy or swivel adapter, ensure the mounting bracket is level, and follow the included wiring instructions with the power off.

Why Slope Angle Matters

The Slide 2 Arm Pendant's sleek design features two shades in balance, but that balance depends on the fixture hanging level. On a sloped ceiling, the canopy must be adjusted to align with the slope, or the pendant will appear tilted.

Most standard mounting brackets are designed for flat ceilings. For slopes greater than 15 degrees, you may need an angled ceiling adapter or a swivel canopy to ensure proper alignment and safety.

Safety and Electrical Considerations

Before starting, turn off power at the circuit breaker to avoid electrical shock. Verify the ceiling box is rated to support the fixture's weight and is securely attached to a joist.

If the ceiling slope is steep, consider using a swag hook or a chain-mount kit to hang the pendant from a flat surface, but note that this changes the fixture's appearance and requires additional hardware.

Installation Steps for Sloped Ceilings

Turn Off Power and Prepare: Switch off the circuit breaker that controls the light fixture. Use a voltage tester to confirm no power is flowing. Gather tools: screwdriver, wire strippers, pliers, and a ladder that is stable on the slope. Always double-check with a voltage tester; never assume the power is off.
Assess Slope and Choose Adapter: Measure the ceiling angle with a protractor or digital level. If the slope exceeds 15 degrees, purchase an angled ceiling adapter or swivel canopy that matches the fixture's mounting pattern. For shallower slopes, a standard canopy may work with adjustment. If the slope is steep, don't skip the adapter; it prevents the pendant from hanging crooked.
Secure the Mounting Bracket: Attach the mounting bracket to the ceiling box, using the provided screws. For sloped ceilings, adjust the bracket so it is level with the floor, not parallel to the ceiling. Use a bubble level to verify. A level bracket is the foundation for a straight pendant; check it twice.
Wire the Fixture: Connect the fixture wires to the house wiring: black to black (hot), white to white (neutral), and green or bare copper to ground. Use wire nuts and wrap with electrical tape. Ensure no bare wire is exposed. If you see any frayed wires, stop and consult a licensed electrician.
Attach Canopy and Adjust Slope: Slide the canopy over the mounting bracket and secure it. If using an adjustable canopy, tilt it to match the ceiling slope while keeping the pendant stem vertical. Tighten all set screws. The canopy should sit flush against the ceiling; gaps indicate misalignment.
Hang the Pendant and Test: Attach the Slide 2 Arm Pendant to the canopy, ensuring both shades are level. Turn the power back on and test the switch. Check that the pendant does not swing or tilt. If the pendant tilts, loosen the canopy and re-adjust before final tightening.

Product Facts

Slide 2 Arm Pendant: The Slide 2 Arm Pendant doubles down on the sleek and simple language of our Slide Family with two shades in balance, hand crafted in Los Angeles. Its balanced design and handcrafted quality mean precise installation is essential to maintain the intended visual symmetry on sloped ceilings.
Slide 2 Arm Pendant